This is the method I use in your scenario, OP. You can use Folder2iso to get the files in that you need. If the OS has official VMware tools, you can also mount the VMware Tools ISO straight from workstation into the VM and this will give you the clipboard service so you can copy and paste files between the host and VM, if this scenario is permitted within your isolation needs.

Otherwise, go the ISO route. You just can’t bring stuff out of the VM back to the host is all.

The two aren’t even in the same league. I’m a big open source advocate don’t get me wrong, but VirtualBox is horrible to use and its not what OP asked.

Its very much still needed and heavily utilised in the enterprise world. Volume size is usually the lowest priority when it comes to arrays, redundancy and IOPS (the amount of concurrent transactions to the storage) is typically the priority. The exception here would be backup and archive storage, where IOPS is less important and volume size is more important.

As far as replacing sectors goes, I’ve never heard of this and I might just be ignorant on the subject but as far as I know you can’t “replace” a bad sector. Only mark it as bad and not use it, and whatever was there before is gone. This has existed since HDD days. This is also why we use RAID - parity across disks to protect data.

Generally production storage will be in RAID-10, and backup/archive storage in RAID-6 or in some cases RAID-60 but I’m personally not a fan.

You also would consider how many disks are in the volume because there is a sweet spot. Too many disks = higher likelihood of total array failure due to simultaneous disk failures and more data loss in the event it does, but too few disks and you won’t have good redundancy, capacity or performance either (depending on RAID level).

The biggest change I see in RAID these days is moving away from hardware RAID cards and into software-based solutions like Microsoft Storage Spaces, md, ZFS and similar. These all have their own way of doing things and some can even synchronise the data with other hosts.

Hope this helps!

Where my download accelerator plus gang at

Sorry I meant TIL about it being considered stable, haha. I’ve known about Fedora because I used it when it was meant to replace the free Red Hat Linux.

As for Steam, I don’t recall how I installed it, sorry! I just recall significant grief getting it going (again, perhaps a skill issue) but had no big roadblocks using OpenSUSE.

TIL about Fedora, last I knew it was a rolling bleeding edge OS. Clearly lots of movement in the Red Hat camp.

As for gaming, drivers were not the problem for me. Getting games to run with ease was. On OpenSUSE, I just install Steam, enable Proton and basically go at that point. Red Hat was non-trivial to do this. Could be a skill issue, but I had a better time getting going with OpenSUSE TW.

Sort of, OpenSUSE Tumbleweed. I started on OpenSUSE Leap but had issues getting things like GPU and Steam working. Red Hat was also a non-starter because of the lack of gaming functionality.

TW works great for gaming and the enterprise features I care about (like domain joining) work out of the box. Its certainly harder to set up than something more geared towards home use (typically one of the various the downstreams of Debian or Arch) but that doesn’t bother me.

Not a distro but maybe Plasma Bigscreen is in the ballpark of what you’re after?